Results 1 to 3 of 3

Thread: Part Failure: Swapping Bolts in a 700?

  1. #1
    Full Member
    Join Date
    Nov 2009
    Location
    WA, USA
    Posts
    1,031

    Part Failure: Swapping Bolts in a 700?

    So my wife and I were out at the range getting her ready for our upcoming deer hunt this coming Saturday. During that time, the bolt handle on her rifle came loose. No big deal really, except my normal 'smith is gone hunting himself, and I don't know if I can get it fixed in time for this coming weekend. If it matters, the bolt is from PTG and was part of a build I had done awhile back. My question: If I have another bolt, can I just swap out, or do I need to be worried about proper headspace?
    1 mil shy of dead center...

    Respect All. Fear None.

  2. #2
    Gunny Sergeant Niles Coyote's Avatar
    Join Date
    Aug 2007
    Location
    South West, MI
    Posts
    3,119
    You will want to verify headspace with a set of gauges... BUT FWIW, all my R700 factory built rifles were GTG when I was checking this a while back, swapping bolts from one to another just for kicks to see what the result would be with my gauges.
    Good transactions (bought and sold) with the following Good Guys:

    http://forum.snipershide.com/firearm...tml#post818781

  3. #3
    Sergeant gewehr's Avatar
    Join Date
    Nov 2013
    Location
    Gillette WY
    Posts
    451
    Make damn sure you check the headspace


    Sent from my iPhone using Tapatalk
    "You give me 5 minutes alone with that Phil Anselmo guy I'll show him who big daddy is!" Father of Heckler
    "You give me 5 minutes alone with that cats dad I''ll whoop his ass" Phil Anselmo